| 6×36 IWRC, ordinary lay | General-purpose overhead-crane hoists where rotation resistance is not the primary requirement. | Approximately 10–32 mm (3/8–1 1/4 in), depending on crane capacity and reeving. | Independent wire-rope core (IWRC) gives a steel core and is commonly used where additional support and strength are required. Minimum breaking force varies with diameter, wire grade, core, and manufacturing specification. | Confirm certified minimum breaking force, required design factor, lay direction, and compatibility with the existing drum and sheaves. |
| 6×19 IWRC, ordinary lay | Hoists or crane systems where a more abrasion-resistant rope is suitable and the equipment is designed for this construction. | Approximately 10–38 mm (3/8–1 1/2 in), depending on the system. | Its comparatively larger outer wires can offer abrasion resistance. Flexibility and fatigue performance differ from finer-wire constructions; strength must be taken from the rope’s certified data. | Check sheave-to-rope diameter ratio, groove condition, bending fatigue demands, and the rope construction specified by the crane manufacturer. |
| Rotation-resistant, 19×7 | Single-fall or multi-fall hoisting arrangements where load rotation must be controlled and the crane is designed for rotation-resistant rope. | Approximately 8–32 mm (5/16–1 1/4 in), subject to equipment design. | Opposing strand layers help reduce torque and load rotation. Its performance depends on correct installation, end termination, and operating conditions; it is not interchangeable with ordinary-lay rope. | Verify the exact rotation-resistant class required, permitted reeving arrangement, termination instructions, and minimum breaking force. |
| Rotation-resistant, 35×7 | Applications requiring a higher degree of rotation resistance, when specifically allowed by the crane design. | Approximately 10–38 mm (3/8–1 1/2 in), subject to equipment design. | Multi-strand construction is designed to resist rotation. Construction-specific handling and inspection requirements apply; nominal diameter alone does not establish capacity. | Confirm suitability for the crane’s drum, sheaves, reeving, terminations, and required service class with the equipment documentation. |
| Compacted-strand crane rope | High-duty hoisting systems designed to use compacted ropes, often where improved surface contact or fatigue performance is needed. | Diameter is specified by the crane design; commonly available in sizes used for industrial hoists. | Compaction can increase metallic cross-sectional area for a given nominal diameter, but actual breaking force and fatigue performance remain product-specific. | Use certified rope data and verify compatibility with the drum grooves, sheaves, end fittings, and inspection criteria. |