| Electrical safety and galvanic isolation | Separates circuits so hazardous voltage or ground faults are less likely to reach control, communication, or user-accessible circuitry. | Check the required isolation type, working voltage, transient voltage, test voltage, and applicable safety standards. Test voltage alone does not establish a device’s permitted working voltage. | Choose a part with ratings and safety approvals appropriate to the end product and installation category. Verify the complete isolation barrier design, including PCB spacing. |
| Common-mode transient immunity (CMTI) | Helps preserve data integrity when the voltage across the isolation barrier changes rapidly, as in switching power converters and motor drives. | Many devices specify CMTI in kV/µs; available ratings vary by device and operating conditions. | Compare the rated CMTI with the fastest expected voltage transition in the application, allowing suitable design margin. |
| Data rate and signal timing | Determines whether the isolator can pass the required signals without missed transitions or excessive delay. | Data rates range from low-speed control to tens or hundreds of Mbps, depending on the device. Propagation delay, pulse-width distortion, and channel-to-channel skew also matter. | Check the maximum data rate and timing specifications against the protocol, clock frequency, duty cycle, and timing budget. |
| Channel count and direction | Affects how many signals can cross the barrier and whether communication can flow in one or both directions. | Devices are available with different channel counts and direction combinations, such as multiple forward channels with one reverse channel. | Map every signal path, including clock, data, enable, and fault signals. Confirm that the channel direction arrangement matches the interface. |
| Power consumption and supply voltage | Influences heat, battery life, and the design of isolated or local power supplies. | Supply-voltage ranges and current vary with device, channel count, data rate, and output loading. | Review current at the intended data rate and load, and confirm that both sides of the isolator have compatible supplies. |
| Output type and logic compatibility | Ensures the isolated signal connects correctly to the processor or interface circuitry. | Check logic thresholds, output drive, default output state, input thresholds, and whether the output is push-pull or open-drain. | Match the isolator’s logic levels and output behavior to the connected circuits, including startup and loss-of-power conditions. |
| Isolation barrier capacitance and emissions | Barrier capacitance can carry common-mode displacement current, potentially affecting emissions, noise, or sensitive measurements. | Barrier capacitance and transient behavior differ among devices and isolation technologies. | For high-noise or low-noise designs, compare barrier capacitance and relevant EMC information, then validate the assembled system. |
| Operating environment and reliability | Temperature, humidity, lifetime, and environmental conditions can affect reliable operation. | Review the rated ambient temperature range, package limits, qualification information, and any application-specific lifetime requirements. | Choose ratings that cover the expected operating environment and assess reliability at the system level. |
| Package and PCB layout | The package and board layout contribute to the physical isolation barrier and affect manufacturability. | Check package dimensions, creepage and clearance requirements, board material, contamination conditions, and any need for slots or coatings. | Follow the device documentation and applicable safety standards. Do not rely on the component alone to guarantee the PCB’s isolation performance. |
| Why use a digital signal isolator? | It can isolate digital control and communication signals while maintaining fast, reliable signal transfer across a galvanic barrier. | Typical benefits include ground-loop interruption, improved noise robustness, and protection of low-voltage circuitry from faults on another circuit. | Use isolation when the system’s safety, grounding, noise, or interface requirements call for it; select the device based on measured system conditions. |
| Note: Numerical ratings and performance vary by device. Use the selected device’s current data sheet and the applicable product safety standards for final design decisions. |