| Engine cranks but does not start | No pump power, a failed pump, low fuel pressure, or another engine-management issue | Check the fuel-pump fuse and relay, then test for power and ground at the pump connector while the pump is commanded on. Verify pressure against the vehicle’s service specification. | On many vehicles, an electric pump in or near the tank sends fuel through the fuel lines toward the engine. |
| No pump sound when the ignition is switched on | The pump may not be receiving power, or the pump itself may have failed. Some vehicles do not run the pump long enough for it to be easily heard. | Listen near the tank during the brief priming period, but do not treat sound alone as a diagnosis. Check the electrical circuit and fuel pressure. | The engine control system may briefly activate the pump at key-on and operate it while the engine is running. |
| Engine hesitates, surges, or loses power under load | Fuel pressure or flow may be insufficient; a restricted filter or line can also contribute, depending on the vehicle’s design. | Measure fuel pressure under the conditions specified in the service procedure. Check for restricted lines or filters and inspect pump-circuit voltage under load. | The pump supplies fuel at a pressure and flow rate suited to the engine’s requirements; the correct values vary by vehicle. |
| The engine stalls and may restart after cooling | An intermittent pump, electrical connection, relay, or wiring fault may be present. | Test the circuit and fuel pressure when the fault occurs. Inspect connectors for looseness, corrosion, or heat damage. | Fuel travels from the tank through the delivery system to the fuel rail or injection components; interruptions can cause the engine to stop. |
| Fuel pressure is below the specified range | A weak pump, restricted supply, poor electrical supply, or a pressure-control fault may be responsible. | Compare gauge readings with the manufacturer’s service specification and follow the prescribed tests before replacing parts. | Fuel pressure must meet the engine’s specified requirements; there is no single pressure value that applies to every vehicle. |
| Pump fuse repeatedly blows | A short circuit, damaged wiring, or an electrical component drawing excessive current may be present. | Do not install a higher-rated fuse. Trace the circuit for shorts and test components using the vehicle’s wiring diagram. | The fuse protects the pump circuit from excessive current; repeated failure indicates an electrical fault that needs diagnosis. |