| System voltage | Nominal system voltage and the switchgear’s rated voltage and insulation levels. | Match the equipment to the system design and applicable insulation requirements. Medium-voltage metal-enclosed switchgear is covered by IEC 62271-200 for rated voltages above 1 kV and up to 52 kV. | Equipment with unsuitable voltage or insulation ratings may not withstand normal operating stresses or transient overvoltages. |
| Transformer load current | Transformer kVA rating, winding voltage, phase configuration, and expected load profile. | For a three-phase transformer, estimate line current using I = S ÷ (√3 × V), where S is apparent power in VA and V is line-to-line voltage in volts. Select continuous-current ratings with the project’s loading and ambient conditions in mind. | Correct current sizing helps prevent excessive heating and supports reliable operation at the transformer’s intended load. |
| Short-circuit withstand and interruption | Prospective fault current at the installation point, fault duration, and the equipment’s making, breaking, and short-time withstand ratings. | Use a system fault study to establish required ratings, then confirm that the switchgear and protective devices are coordinated with the transformer and upstream network. | Fault levels depend on the network and transformer impedance; ratings should not be selected from transformer capacity alone. |
| Protection and switching arrangement | Required protection functions, operating frequency, remote-control needs, and the consequences of a fault. | A fused switch may suit some transformer-feeder applications; a circuit breaker with relays may be preferable where adjustable protection, repeated switching, or more detailed monitoring is required. Verify coordination with upstream and downstream devices. | The appropriate arrangement depends on system design, utility requirements, protection study results, and operating procedures. |
| Switchgear construction | Available space, installation location, access, and maintenance strategy. | Air-insulated equipment can be suitable where space and environmental protection are adequate. Gas-insulated or other sealed designs can reduce footprint, but their operating and maintenance requirements should be assessed. | Construction affects footprint, installation layout, service access, and the procedures needed over the equipment’s life. |
| Indoor or outdoor environment | Ambient temperature, humidity, dust, altitude, corrosion, water exposure, and enclosure requirements. | Confirm the specified service conditions and enclosure protection for the actual site. Apply any required derating or design provisions identified by the project and equipment documentation. | Site conditions can affect insulation performance, cooling, corrosion resistance, and safe access. |
| Safety and access | Interlocking, earthing provisions, internal-arc requirements, operating position, and access control. | Specify safety features based on the installation risk assessment, applicable regulations, and operating procedures. Where internal-arc classification is required, confirm the relevant test classification and installation conditions. | Safety depends on equipment design as well as installation, maintenance, and correct operating practices. |
| Standards and compatibility | Applicable local rules, utility specifications, interface dimensions, cable termination, and control-system requirements. | Check the relevant product standards for the equipment type, such as IEC 62271 for high-voltage switchgear and controlgear, and IEC 60076 for power transformers. Confirm all project-specific interfaces before ordering. | Compliance and interface checks support safe integration and help avoid installation delays or incompatible connections. |
| Lifecycle and serviceability | Inspection intervals, spare parts, maintenance access, monitoring, and end-of-life handling. | Compare the documented maintenance plan and total lifecycle needs, not only initial purchase cost. Confirm the availability of service support and required operating tools. | A suitable lifecycle plan can improve maintainability and help manage ownership costs and equipment availability. |