| How It Measures Humidity | A moisture-sensitive polymer absorbs water vapor, changing the sensor’s capacitance or, in some designs, resistance. Electronics convert that change into relative humidity (RH). | A porous ceramic material changes its electrical properties as it adsorbs or releases water vapor. Depending on the design, the sensor may measure capacitance or electrical resistance. | A mirror is cooled until water vapor begins to condense on its surface. The temperature at condensation is the dew point; RH can be calculated using the dew point and air temperature. |
| Primary Measurement | Usually relative humidity, with temperature often measured nearby for compensation. | Usually relative humidity or a humidity-related electrical signal, depending on the sensor design. | Dew-point temperature. Relative humidity is derived when air temperature is also measured. |
| Typical Accuracy | About ±2–3 percentage points RH for many calibrated devices under specified conditions. | Often about ±3–5 percentage points RH for general-purpose designs; performance varies substantially with construction and calibration. | High-quality instruments commonly specify dew-point accuracy around ±0.1–0.2°C. This is not directly equivalent to an RH accuracy specification. |
| Typical Operating Conditions | Many designs cover 0–100% RH and approximately −40 to +85°C, but limits differ by sensor and protective packaging. | Operating limits are design-specific. Some models tolerate high temperatures and harsh environments; the usable RH and temperature ranges must be checked for the particular sensor. | Measurement range depends on the instrument’s cooling capacity and temperature limits. It can measure dew points below ambient temperature, but no single range applies to all designs. |
| Response and Stability | Generally fast and suitable for continuous monitoring. Long-term drift can occur, especially after exposure to contaminants or prolonged high humidity. | Response and stability depend on material and construction. Some designs are robust, but calibration and recovery characteristics vary. | Often slower because the mirror must reach and control the condensation point. Stable, repeatable results are possible when the mirror is clean and the instrument is maintained. |
| Main Advantages | Compact, low power, relatively inexpensive, and easy to integrate into automated weather stations. | Can be useful in demanding environments, with certain designs offering good thermal or mechanical durability. | Direct dew-point measurement provides a reference-style method and can support accurate humidity checks when properly maintained. |
| Main Limitations | Can be affected by chemical vapors, dust, condensation, aging, and rapid temperature changes. A radiation shield and suitable siting are important outdoors. | “Ceramic sensor” describes a broad family rather than one uniform technology. Some designs may have lower precision or slower response than calibrated polymer sensors. | Typically more expensive, larger, and more maintenance-intensive than electronic RH probes. Dust or deposits on the mirror can impair measurement. |
| Typical Weather-Station Role | A common choice for routine outdoor RH and temperature monitoring. | Used where the selected sensor’s environmental tolerance suits the installation; verify its specific accuracy and operating limits. | More often used for reference measurements, instrument comparison, or specialized monitoring than for a basic, low-maintenance station. |
| Data Interpretation Note | Specifications shown are representative, not universal guarantees. Accuracy, range, response time, and maintenance needs vary by sensor design, calibration, installation, and environmental conditions. RH is temperature-dependent, so accurate air-temperature measurement and proper shielding from direct sunlight and precipitation are important. |