| Measurement range | Confirm the sensor’s velocity range and whether it suits the expected vibration levels at the measurement point. Range specifications may be expressed in units such as mm/s or in/s. | What are the measurement range, overload limits, and stated conditions for those ratings? | Allow suitable headroom above the expected operating level, while ensuring the sensor can resolve the minimum signal of interest. |
| Frequency response | Check the usable frequency band and how response limits are specified, including any sensitivity variation across the band. | Is the response specified with tolerances, and are mounting conditions included in the performance data? | Match the usable band to the machine’s expected vibration frequencies and the monitoring or diagnostic task. |
| Output and system compatibility | Common options include dynamic outputs such as IEPE and conditioned outputs such as 4–20 mA. These serve different monitoring and control system requirements. | What supply, signal conditioning, cable, and input requirements apply to each output option? | Verify compatibility with the data-acquisition system, PLC, monitor, or other receiving equipment before ordering. |
| Measurement units and signal definition | Vibration velocity may be reported as RMS, peak, or peak-to-peak, depending on the sensor system and application. | How is the output scaled, and which amplitude convention and units are used? | Use consistent units and amplitude definitions across sensors, monitoring equipment, and alarm settings. |
| Mounting and installation | Review mounting method, mounting surface requirements, orientation, connector location, and cable routing. Installation can affect measured vibration. | Which mounting options are available, and what installation practices are required for the stated performance? | Confirm the sensor can be installed securely at the intended point and that the mounting method suits the machine and maintenance plan. |
| Environmental protection | Check operating temperature, ingress protection, humidity resistance, and resistance to oil, dust, or other site conditions where applicable. | Which environmental ratings apply to the complete sensor and connector assembly? | Compare documented ratings with actual site conditions; do not assume the sensor body rating also covers cable connections. |
| Hazardous-area requirements | For installations in classified hazardous locations, equipment may need certification appropriate to the location and protection method. | Can the supplier provide valid certificates and installation instructions for the required jurisdiction and zone or division? | Check that the exact model, accessories, and intended installation are covered by the required approval. |
| Accuracy and calibration | Compare sensitivity tolerance, linearity, repeatability, and any stated calibration interval or calibration service. | Is a calibration certificate supplied, and does it identify the tested unit and measurement conditions? | Review the calibration documentation and determine whether its traceability and uncertainty meet the application’s requirements. |
| Reliability and service life | Assess construction, connector and cable options, operating limits, warranty terms, and available repair or replacement support. | What warranty applies, and what repair, replacement, or technical-support process is available internationally? | Compare the documented terms and support arrangements rather than relying on general reliability claims. |
| Documentation and standards | Request clear datasheets, wiring diagrams, installation instructions, and applicable conformity or quality-system documentation. Machine vibration evaluation standards are distinct from sensor performance specifications. | Can the supplier provide current documentation for the exact model and relevant configuration? | Use the sensor specifications for instrument selection and consult the applicable machine-vibration criteria separately for evaluation limits. |
| Supply, lead time, and lifecycle | Compare quoted lead times, regional availability, product-change notifications, and availability of compatible replacement models. | How are lead times confirmed, and how much notice is given for product changes or discontinuation? | Check delivery commitments and plan for spares if downtime or long procurement cycles would affect operations. |
| Total cost of ownership | Consider the sensor price alongside required cables, signal conditioning, mounting hardware, calibration, installation, and ongoing support. | Which accessories or services are required but not included in the quoted price? | Compare complete, compatible system costs rather than sensor prices alone. |