| Marine fuel hose for small craft | Fuel-resistant elastomers are selected for the fuel type and hose design; nitrile rubber (NBR) is commonly used in fuel-contacting layers. | Textile reinforcement is common; the outer cover is selected for resistance to the intended marine environment, including oil, abrasion, and weather exposure. | ISO 7840 covers fire-resistant fuel hoses for small craft. ISO 8469 covers non-fire-resistant fuel hoses for small craft. SAE J1527 also addresses marine fuel hoses. | Confirm the hose is certified or declared for the intended fuel, installation location, and fire-resistance category. Verify construction, markings, and applicable test documentation. |
| Engine seawater cooling hose | Rubber or plastic compounds are selected for seawater, engine-cooling conditions, and the specified temperature range. EPDM is often used where heat and water resistance are required. | Textile reinforcement is typical; the cover is designed for the installation environment and may include resistance to weathering and abrasion. | ISO 13363 specifies requirements for rubber and plastic hoses used in seawater cooling systems for marine engines. | Check the declared working conditions, hose dimensions, bend radius, and compatibility with the cooling system. Do not assume a cooling hose is suitable for fuel or oil. |
| Oil suction and discharge hose assemblies | Oil-resistant rubber compounds, often including NBR-based tube formulations, are used according to the oil and service conditions. | Textile and/or metallic reinforcement may be used to meet pressure, vacuum, and handling requirements; the cover is selected for the operating environment. | EN 1765 specifies requirements for rubber hose assemblies used for oil suction and discharge services. | Verify whether the assembly is rated for suction, discharge, or both. Check working pressure, vacuum rating, end connections, and inspection or test records. |
| Chemical transfer hose | Material depends on the chemical: PTFE or other compatible fluoropolymers may be used for demanding chemical service; suitable rubber or thermoplastic compounds are used for other media. | Textile or metallic reinforcement may be incorporated depending on pressure, flexibility, and permeation requirements. The cover and any fittings must also be compatible. | EN 12115 covers rubber and thermoplastic hoses and hose assemblies for liquid or gaseous chemicals. | Check a chemical-compatibility chart for the exact medium, concentration, temperature, and exposure conditions. Confirm permeation, cleaning, and assembly limitations with the supplier. |
| Offshore mooring and tanker hose service | Elastomeric tube compounds are selected for the transported product and the hose design; material choice is specific to the service. | Heavy-duty textile and/or metallic reinforcement may be used. Hose construction and end fittings are designed for the required offshore operating configuration. | OCIMF’s GMPHOM guidance addresses the manufacture and purchase of hoses for offshore moorings. | Specify the hose system and service conditions, then review design qualification, production testing, traceability, and inspection requirements against the applicable project specification. |
| General marine hose construction | Common material families include NBR for many oil or fuel-contact applications, EPDM for many water and weather-exposed applications, and PTFE for selected chemical or high-temperature services. | Reinforcement may use textile, steel wire, or a combination. Covers may be formulated from rubber or thermoplastic compounds for weather, abrasion, oil, or chemical exposure. | The applicable standard depends on the hose’s intended use; a material description alone does not establish compliance with a product standard. | Review the complete assembly: tube, reinforcement, cover, fittings, manufacturing controls, dimensional checks, pressure or vacuum tests, and required product markings. |
| Selection note: Standards apply to defined product types and service conditions. Confirm the current edition, required certification, media compatibility, pressure and temperature limits, and installation requirements for the specific vessel and application. |