| Dropout fuse cutout | The fuse link is housed in a hinged fuse tube. When the link operates, the tube drops open, providing a visible indication that the fuse has blown and helping isolate the circuit. | Usually mounted outdoors on a utility pole, crossarm, or transformer structure. Single-phase units are commonly installed individually; three units may be used for a three-phase circuit. | Overhead distribution feeders, transformer primary protection, and taps or laterals. | Check rated voltage, continuous current, interrupting capability, insulation level, fuse-link compatibility, and the required coordination with upstream and downstream protection. |
| Non-dropout expulsion fuse | The fuse element operates within an expulsion tube, but the assembly is designed not to drop open after operation. Fault interruption still relies on the expulsion-fuse design and its specified operating conditions. | Mounted on a fixed outdoor support or equipment structure, following the manufacturer's specified orientation and clearances. | Installations where a falling fuse tube is not desired or where the equipment arrangement calls for a fixed assembly. | Confirm the exact product construction and indication method; a non-dropout unit may not provide the same visible open-gap indication as a dropout cutout. |
| Open-type expulsion fuse | The interrupting tube is exposed to the surrounding air. As the fuse link operates, gases generated inside the tube help extinguish the arc. Many overhead dropout cutouts use this general arrangement. | Typically mounted outdoors on poles, crossarms, or other open-air distribution structures. | Overhead distribution systems where the equipment can be installed with suitable phase spacing and exhaust clearances. | Provide the clearances and installation environment required by the applicable standards and manufacturer. Expulsion gases and noise during interruption must be considered. |
| Enclosed expulsion fuse | The expulsion fuse is housed within an enclosure designed for the specific fuse assembly. The enclosure does not eliminate the need to follow the product's requirements for gas discharge, ventilation, and fault interruption. | Installed in equipment or a structure specifically designed and approved for that fuse type; mounting may be indoors or outdoors only where the equipment rating permits. | Selected distribution or equipment applications that require an enclosed fuse arrangement compatible with the installation. | Verify enclosure compatibility, ventilation and exhaust provisions, accessibility, environmental rating, and the fuse's tested interrupting rating. Do not substitute an open-type fuse in an enclosure without approval. |
| Single-pole, individually mounted arrangement | One fuse assembly protects one phase. A single-pole arrangement describes the installation configuration rather than a different arc-extinguishing mechanism. | Mounted separately on a pole, crossarm, transformer bracket, or equipment support. | Single-phase circuits and individual phase protection on overhead distribution systems. | Confirm phase-to-ground insulation requirements, structural loading, safe operating access, and coordination with other protective devices. |
| Three-pole or three-unit arrangement | Three single-pole fuse units are installed to protect a three-phase circuit. They may operate independently unless the system includes a separate mechanism designed to operate them together. | Mounted as three separate units or on a common support, with spacing and orientation set by the equipment design. | Three-phase overhead feeders, transformer connections, and other distribution equipment. | Consider phase coordination, the consequences of single-phasing, required clearances, and whether the protection scheme calls for independent or linked operation. |