| 1 | Casement operation | The sash is hinged at the side and operated with a handle or crank; opening direction depends on the design. | Allows the sash to open wide for ventilation and can direct airflow into a room. | Confirm hinge side, opening direction, hardware position, and clearance from nearby walls or walkways. |
| 2 | Aluminum frame | Aluminum profiles form the frame and sash; profile depth and internal design vary by product. | Aluminum is lightweight relative to its strength and can support slim frame sightlines. | Review frame dimensions, structural documentation, and the visible frame width for the chosen size. |
| 3 | Thermal break | Thermally improved frames use a low-conductivity barrier between interior and exterior aluminum sections. | Reduces heat transfer through the frame compared with a non-thermally broken frame. | Ask whether the frame is thermally broken and compare whole-window thermal ratings, not frame descriptions alone. |
| 4 | Glazing options | Available configurations can include single, double, or triple glazing, with glass coatings or gas-filled cavities depending on the product. | Glass selection affects insulation, solar heat gain, visible light, and sound reduction. | Check the complete glazing build-up and certified whole-window U-factor and solar heat gain coefficient (SHGC), where available. |
| 5 | Weather seals | Gaskets and weatherstripping are fitted around contact points between the sash and frame. | Properly designed and maintained seals help limit air and water entry when the window is closed. | Review air-leakage and water-penetration test results for the relevant window configuration. |
| 6 | Hardware and locking | Hinges, an operator, and one or more locking points are used; hardware layouts differ by design and size. | Hardware supports sash movement, closure, and engagement with the frame. | Check operation, adjustment access, corrosion suitability for the location, and availability of replacement parts. |
| 7 | Air leakage performance | Air leakage is measured through testing under a stated method and pressure; results are product-specific. | A lower reported leakage value indicates less air passing through the tested window under the test conditions. | Compare values using the same test method, units, and product size where possible. |
| 8 | Water and wind performance | Test ratings depend on the complete window assembly, dimensions, glazing, hardware, and installation details. | Relevant ratings help assess suitability for local exposure and building requirements. | Request documented water-penetration and structural-pressure results for the intended size and application. |
| 9 | Surface finish | Common aluminum finishes include anodized surfaces and factory-applied paint coatings, including powder-coated finishes. | Finish affects appearance and surface protection; suitability depends on the environment and maintenance. | Check the finish specification, care instructions, warranty terms, and suitability for coastal or industrial conditions. |
| 10 | Installation and drainage | The frame must be installed plumb, level, and square; drainage paths and flashing details are part of the opening assembly. | Correct installation helps the window operate as designed and directs incidental water away from the building interior. | Follow the product installation instructions and coordinate sill drainage, flashing, and wall-system details. |