| 1. Select the right power rating | Confirm the continuous power dissipation at the expected ambient temperature, and review the supplier’s derating curve. | Common axial metal film ratings include 0.125 W, 0.25 W, 0.5 W, and 1 W. Actual ratings and derating limits vary by series. | Operating too close to the rated limit can increase component temperature and reduce reliability. Allow suitable design margin. |
| 2. Check resistance tolerance | Match the initial resistance accuracy to circuit requirements, and confirm the tolerance is specified at the stated test conditions. | Common options include ±1%; tighter options such as ±0.5%, ±0.1%, or better may be available for selected values and series. | Tolerance affects initial circuit accuracy. Tighter tolerance may influence cost, availability, and minimum order quantities. |
| 3. Review temperature stability | Check the temperature coefficient of resistance (TCR), expressed in parts per million per degree Celsius (ppm/°C). | Metal film parts are commonly offered with TCR ratings such as ±100 ppm/°C; precision series may specify ±50, ±25, or lower. | Lower TCR generally means less resistance change as component temperature varies. Compare the required operating temperature range and the datasheet test method. |
| 4. Verify body and lead dimensions | Confirm body length and diameter, lead diameter, lead spacing after forming, and available PCB footprint. | Typical small axial parts may have bodies around 3–6 mm long and 1.5–2.5 mm in diameter; larger power ratings often use larger bodies. Dimensions vary by series. | Dimensions affect board layout, automated insertion, clearance, and thermal behavior. Use the exact drawing for the selected part rather than a nominal size alone. |
| 5. Check maximum working voltage | Compare the circuit’s continuous voltage with the resistor’s rated limiting element voltage and applicable power limit. | Maximum working voltage is series-specific and may be lower than expected from resistance and power alone. Consult the datasheet, especially for high resistance values. | A resistor can exceed its voltage limit even when calculated power dissipation appears acceptable. Observe any specified voltage derating. |
| 6. Assess environment and reliability needs | Review operating temperature range, moisture or coating requirements, load life, solderability, and any required qualification or compliance documents. | Many general-purpose axial metal film series specify operating ranges such as −55°C to +155°C, but limits depend on the product and power derating. | Environmental ratings and test results are not interchangeable across series. Request current datasheets and declarations that match the exact part number and destination market. |
| 7. Confirm packaging and traceability | Specify bulk, tape-and-reel, or other packaging; check quantity per pack, lead-forming options, date/lot coding, and documentation requirements. | Axial resistors may be supplied loose or in formed-lead or tape packaging, depending on the series and ordering code. | Packaging affects assembly compatibility, handling, and replenishment. Confirm that the ordered code corresponds to the required packaging and traceability level. |