| Cooling performance | 25% | Confirm the stated operating temperature range and whether the unit can maintain the required temperature under the specified ambient conditions and loading. | Model-specific technical datasheet, operating manual, and temperature test results with test conditions stated. | Performance figures identify the test conditions, intended use, and temperature range. | Only a single temperature figure is provided, with no test conditions or operating limits. |
| Temperature consistency | 15% | Check temperature variation between shelves and compartments, recovery after door opening, and the location and readability of the temperature display. | Temperature mapping or test records covering multiple measurement points and a stated test period. | The seller explains the measurement method and provides results from more than one point in the cabinet. | A display reading is presented as proof of uniform temperature throughout the cabinet. |
| Energy efficiency | 20% | Compare energy use for units of similar type, capacity, and intended application. Check whether consumption is reported in kWh per 24 hours or another clearly defined unit. | Model-specific test report showing the measured energy consumption, test method, ambient conditions, and cabinet configuration. | The figures are tied to the exact model and comparable test conditions; any claimed energy label can be checked against its applicable scope. | A low energy-use claim is given without a test method, unit, or supporting report. |
| Construction and insulation | 15% | Inspect door seals, hinges, panel joints, internal surfaces, drainage, and ease of cleaning. Check the stated insulation material and construction details. | Product drawings or specifications, material details, and an inspection of the finished unit or a representative sample. | Doors close evenly, seals contact the frame, surfaces are accessible for cleaning, and construction details are documented. | Loose seals, sharp or unfinished edges, standing water, or vague material descriptions. |
| Electrical safety and certification | 15% | Identify the exact model and intended market. Verify which mandatory Chinese certification requirements, if any, apply to that product category; requirements depend on product scope. | Applicable certification documents and model details. Where a CCC certificate is claimed, check the certificate status and scope through an official certification information service. | Certificate details match the exact model and product category, and the seller can explain any applicable requirements. | A certificate for a different model is offered, or a certification mark is shown without verifiable documentation. |
| Food-contact materials | 5% | For surfaces intended to contact food, identify the material and check the applicable Chinese food-contact material requirements for that material and use. | Material declarations and relevant compliance or test documents. GB 4806.1 is a general safety standard for food-contact materials and articles; material-specific standards may also apply. | Documentation identifies the material, intended food-contact use, and applicable standards. | The seller describes a surface as “food grade” but cannot identify its material or provide supporting documents. |
| Serviceability and warranty | 5% | Confirm warranty coverage, response arrangements, availability of replacement parts, and maintenance instructions for the installation location. | Written warranty terms, service contact details, parts list, and maintenance schedule. | Terms clearly state coverage, exclusions, service process, and parts support. | Warranty promises are verbal, unclear, or not tied to the supplied model. |