| Channel Count and Direction | Number of isolated channels and signal direction on each channel. | Common configurations include 1 to 6 channels, with options for all-forward, all-reverse, or mixed-direction signals. | Match the channel count and direction to the interface signals. Allow spare channels only when the added cost and board area are justified. |
| Data Rate and Timing | Maximum data rate, propagation delay, pulse-width distortion, and channel-to-channel skew. | Available data rates vary by device; many families offer options from a few megabits per second to tens or over 100 megabits per second. | Choose a data-rate rating above the required signal rate, then verify timing limits at the intended supply voltage and temperature. |
| Power Requirements | Supply voltage, current, logic-level compatibility, and whether isolated-side power is required. | Digital isolators commonly use separate supplies on each side. Some products integrate isolated power, while others require an external isolated DC/DC converter. | Check both sides’ supply ranges and budget total system power, including any external converter. Integrated power can simplify the design but may have different output-current or noise limits. |
| Isolation Rating | Withstand voltage, working voltage, surge capability, and applicable safety approvals. | Withstand ratings are test values and are not interchangeable with continuous working-voltage ratings. Ratings and test conditions differ among devices and standards. | Use the working voltage and safety requirements of the end application to select a device. Confirm the relevant test duration, standard, and approval documentation. |
| Common-Mode Transient Immunity | Common-mode transient immunity (CMTI), usually specified in kV/µs. | Many devices specify CMTI in the tens of kV/µs or higher; the guaranteed value depends on the device and test conditions. | Select a rating with margin over expected switching transients, especially near fast-switching power stages. Review the datasheet test setup and logic-state conditions. |
| Package and Board Layout | Package dimensions, pin count, creepage and clearance, and PCB footprint. | Common package styles include narrow-body and wide-body surface-mount packages. Package dimensions and isolation spacing vary by construction and rating. | Confirm the footprint and required board-level creepage and clearance. Do not assume that a package name alone guarantees compliance with a specific system insulation requirement. |
| Operating Environment | Operating temperature range, humidity exposure, vibration, and contamination conditions. | Commercial-temperature parts are often rated around 0°C to 70°C; industrial options commonly extend to about −40°C to 85°C or higher. Exact limits are device-specific. | Choose a temperature grade that covers the measured ambient and board temperatures, with margin. Check qualification and environmental limits for the application. |
| Fail-Safe Output Behavior | Output state when the input is floating, unpowered, or across a power-up or power-down transition. | Some devices default to a logic-high output and others to logic-low; behavior depends on the device and pin configuration. | Match the default state to the system’s safe condition and verify behavior during startup, shutdown, and loss of either-side power. |
| EMC and Signal Integrity | Input thresholds, output drive, edge rate, decoupling, and sensitivity to board-level coupling. | Fast edges and long traces can increase ringing or emissions. Local bypass capacitors are generally recommended near each supply pin pair. | Follow the datasheet layout guidance, keep bypass paths short, and evaluate signal integrity and emissions in the final PCB layout. |
| Qualification and Compliance | Safety certifications, component qualification, and documentation needed for the end product. | Approvals and qualification status vary by device and may apply only under specified conditions. | Verify certificates, ratings, and qualification records against the requirements of the target market and end application. |
| Typical ranges are illustrative selection guidance, not guaranteed specifications. Confirm all electrical, thermal, isolation, and compliance limits in the selected device’s datasheet. |