| 6 mm slab | Approx. 14.4–15.6 kg/m², using an indicative density of 2,400–2,600 kg/m³. | Lower weight can suit wall cladding and some renovation overlays. It generally needs a suitable, continuous support system and careful handling. | Approved installation method, substrate condition, panel size, edge details, and handling requirements. |
| 12 mm slab | Approx. 28.8–31.2 kg/m², using the same indicative density range. | A common choice for countertops and interior surfaces when the design and support system are suitable. Cutouts and unsupported spans still need careful planning. | Fabricator guidance for overhangs, sink and cooktop cutouts, edge profiles, and reinforcement. |
| 20 mm slab | Approx. 48–52 kg/m², using the same indicative density range. | The added thickness gives a more substantial appearance and may suit countertop designs, but increases handling and support demands. | Cabinet capacity, transport and lifting arrangements, cutout design, and the supplier’s installation recommendations. |
| Water absorption | Dense sintered surfaces typically have very low water absorption; the declared result varies by product and test method. Porcelain tile classification BIa under ISO 13006 specifies water absorption of no more than 0.5%. | Low absorption can help limit liquid uptake, but does not make seams, edges, backing, or installation details waterproof. | The product’s published test result and the applicable standard; confirm whether the stated value applies to the slab itself. |
| Heat and thermal shock | The mineral-based surface is generally heat resistant, but performance depends on the product, thickness, support, and temperature change. | Suitable for many kitchen and interior uses when installed correctly. Sudden temperature changes or concentrated loads can still cause damage. | Published heat or thermal-shock test data, and the supplier’s guidance on hot cookware and appliance clearances. |
| UV and color stability | Many sintered surfaces have good resistance to UV-related color change; results depend on the specific product and finish. | Can be considered for areas exposed to daylight or outdoor conditions when the product is rated for that use. | Exterior-use suitability, UV test data, temperature limits, and any warranty conditions. |
| Scratch, abrasion, and finish | Resistance varies with composition and surface finish. Polished, matte, and textured finishes may behave differently and show wear differently. | Choose a finish suited to expected traffic and cleaning. No surface should be assumed scratch-proof; use cutting boards and appropriate cleaning tools. | Finish-specific test data, cleaning instructions, and a sample viewed under the project’s lighting. |
| Stain and chemical resistance | The dense surface is generally easy to clean, but resistance to particular stains and chemicals is product-specific; joints and exposed edges may need separate care. | A practical option for many kitchens and bathrooms when spills are cleaned promptly and the recommended cleaners are used. | Chemical-resistance data, approved cleaners, and instructions for removing persistent stains. |
| Fabrication and installation | Large-format slabs require suitable cutting equipment, trained fabricators, planned seams, and appropriate support. Cutouts and edges are potential stress points. | A suitable slab can still fail if handling, cutting, support, or installation is inadequate. Include fabrication constraints in the design stage. | Slab dimensions, tolerances, approved adhesives and supports, fabricator experience, and written installation instructions. |