| Indicative airflow and pressure ranges |
| Small workshop with intermittent pneumatic tools | About 0.5–2.0 m³/min (18–71 cfm); commonly 6–8 bar(g) (87–116 psig) at the point of use. | Base the estimate on the tools likely to operate at the same time, rather than adding every tool’s maximum demand. |
| Assembly or general manufacturing area | About 2–10 m³/min (71–353 cfm); commonly 6–8 bar(g) (87–116 psig) at the point of use. | Check the demand of production equipment during peak operation and include any continuous air users. |
| Small or medium CNC and metalworking shop | About 1–8 m³/min (35–283 cfm); commonly 6–8 bar(g) (87–116 psig) at the point of use. | Confirm the machine manufacturer’s pressure and airflow requirements; blow-off and auxiliary equipment can affect peak demand. |
| Larger multi-line production facility | About 10–50 m³/min (353–1,766 cfm); many systems operate around 7–10 bar(g) (102–145 psig), depending on equipment. | Use measured plant demand or a detailed equipment schedule. Consider multiple compressors where capacity control, redundancy, or changing loads require it. |
| How to establish the required compressor capacity |
| Airflow basis | Use free air delivery (FAD), normally stated in m³/min or cfm at a specified discharge pressure. | Compare compressor FAD with the calculated or measured peak demand at the required operating pressure. Check that competing offers use the same rating conditions and standard. |
| Simultaneous demand | Sum the airflow of equipment expected to run together, accounting for duty cycles where reliable operating data is available. | Do not size from connected load alone or assume every machine runs continuously. A demand profile or flow measurement can help identify actual peaks. |
| Growth and leakage allowance | Estimate planned future demand and address leakage separately where possible. | Add only a justified allowance for documented growth or uncertainty. Repairing leaks is generally preferable to oversizing the compressor to cover them. |
| How to establish the required pressure |
| Pressure at the equipment | Use the minimum pressure specified by the equipment manufacturer, measured while the equipment is operating. | Pressure measured with no airflow may not show the pressure available during peak demand. |
| Distribution and treatment losses | Account for the pressure drop through pipework, filters, dryers, separators, and other components at the required airflow. | Set compressor discharge pressure high enough to meet the point-of-use requirement after these losses. Use measured or component-rated pressure drops rather than an arbitrary increase. |
| Pressure example | If equipment requires 6.5 bar(g) and the measured combined system pressure drop is 0.5 bar, the compressor must supply approximately 7.0 bar(g) under that operating condition. | Recheck pressure drop at peak flow; restrictive or undersized components can cause larger losses as airflow increases. |
| Units and conversions | 1 m³/min ≈ 35.3 cfm; 1 bar ≈ 14.5 psi. “bar(g)” means pressure above atmospheric pressure. | Keep units consistent when comparing equipment demand, compressor capacity, and pressure requirements. |