| Indoor equipment panels and general enclosures | Dry indoor conditions; occasional cleaning; limited exposure to salts or chemicals | 304 / 304L | General corrosion resistance, clean appearance, and adequate formability for bends and cut-outs | Confirm finish, sheet flatness, thickness tolerance, and whether the part will be welded or formed |
| Coastal or chloride-exposed components | Marine atmosphere, salt spray, or regular contact with chloride-containing water | 316 / 316L; assess the specific exposure before final selection | Improved resistance to chloride-related pitting and crevice corrosion compared with 304 in many environments | Review chloride concentration, temperature, crevices, cleaning regime, and required corrosion testing |
| Food-service counters and washable interior surfaces | Frequent washing and contact with food residues; chemical cleaners may be used | 304 / 304L; consider 316 / 316L for more aggressive chloride or cleaning exposure | Smooth, cleanable surface; suitable corrosion resistance; finished edges and welds that can be cleaned | Specify surface finish and cleaning chemicals; confirm relevant hygiene and fabrication requirements |
| Decorative trim and indoor architectural panels | Interior use with emphasis on appearance and surface consistency | 304; 430 may suit some dry indoor decorative uses where its properties are acceptable | Consistent finish, scratch management, dimensional stability, and suitable forming behavior | Approve a finish sample; confirm grain direction, protective film, and whether magnetic response is acceptable |
| Magnetic covers, appliance parts, or lightly corrosive indoor components | Mostly dry indoor service; magnetic response may be useful or required | 430, subject to forming and corrosion requirements | Magnetic behavior and suitable performance in a mild environment; generally less corrosion resistant than 304 | Check exposure to moisture and cleaning agents, forming limits, and the required magnetic response |
| Bent brackets, guards, and formed covers | Parts require press-brake forming, punched features, or multiple bends | 304 / 304L is commonly considered; confirm the selected product’s forming properties | Bendability, crack-free edges, springback control, and sufficient stiffness for the part geometry | Provide bend radii and grain direction; conduct a forming trial for tight bends or complex shapes |
| Welded tanks, trays, or fabricated assemblies | Welded construction; service conditions depend on the stored or processed material | 304L or 316L may be considered where low-carbon grades are specified for welded service | Weldability, corrosion resistance at welds, cleanable joints, and suitability for the contents and process | Define the welding procedure, post-weld cleaning, operating temperature, and chemical exposure |
| Weight and material planning | Estimating sheet mass before cutting or fabrication | Use the specified grade density and actual supplied thickness for the estimate | At 1.5 mm thickness, theoretical mass is about 12.0 kg/m² for austenitic grades near 8.0 g/cm³ and about 11.6 kg/m² for 430 near 7.7 g/cm³ | Treat figures as estimates; actual mass varies with grade, thickness tolerance, and sheet dimensions |
| All applications | Any environment where service life, safety, or compliance matters | Select by service conditions rather than thickness alone | 1.5 mm describes nominal thickness; it does not by itself establish load capacity, corrosion life, or suitability | Specify grade and product standard, thickness tolerance, finish, certification, dimensions, and any testing requirements |