| Helical | About 3:1–100:1, depending on the number of stages | About 90–97% for many designs | From a few Nm to tens of thousands of Nm, depending on frame size and ratio | Conveyors, mixers, packaging lines, and general industrial drives | Good choice when efficiency and continuous operation matter. Check mounting position, shaft arrangement, service factor, and thermal capacity. |
| Worm | About 5:1–100:1 or higher in selected designs | Often about 50–90%; varies substantially with ratio, materials, and operating conditions | From a few Nm to several thousand Nm, depending on size | Compact right-angle drives, lifts, gates, and low-speed machinery | Compact and quiet, but efficiency and heat generation need careful review, especially at high ratios and under continuous duty. |
| Bevel-helical | Commonly about 6:1–200:1 across available configurations | About 90–96% for many designs | From tens of Nm to tens of thousands of Nm, depending on frame size | Right-angle conveyors, material handling, and process equipment | Useful where a right-angle shaft layout and high load capacity are needed. Confirm shaft orientation, mounting, and permitted radial and axial loads. |
| Planetary | Commonly about 3:1–100:1; multiple stages can provide higher ratios | About 90–97% for many designs | From a few Nm to tens of thousands of Nm, depending on size and configuration | Servo axes, robotics, indexing equipment, and compact high-torque drives | Offers high torque density and compact dimensions. Check backlash, peak torque, radial load, and compatibility with the motor flange. |
| Parallel-shaft helical | Commonly about 3:1–200:1, depending on stages | About 90–97% for many designs | From a few Nm to tens of thousands of Nm, depending on size | Conveyors, feeders, and machinery requiring an in-line or parallel shaft layout | Compare shaft position, output-shaft options, mounting orientation, and the space available for the gearbox. |
| Specifications Global Buyers Should Confirm Before Ordering |
| Specification | What to State | Why It Matters |
| Rated power and speed | Motor output power in kW, motor rated speed in rpm, and required gearbox output speed in rpm | These values establish the drive operating point. For an approximate ratio, divide motor speed by the required output speed, then confirm the available ratio and resulting torque with the supplier. |
| Output torque and load profile | Required continuous torque, peak or starting torque, load type, starts per hour, and operating hours | A gearbox must handle both steady and transient loads. Shock loads and frequent starts may require a higher service factor or a different design. |
| Electrical supply | Available voltage, frequency, phase, and whether a variable-frequency drive will be used | Motor voltage and frequency must match the installation. Common industrial supplies include three-phase 400 V at 50 Hz and 460 V at 60 Hz, but availability varies by country and site. |
| Mounting and output arrangement | Foot or flange mounting, mounting position, shaft direction, and solid or hollow output shaft | The correct arrangement is essential for mechanical fit, lubrication, and installation. Confirm dimensions and allowable shaft loads on the drawing. |
| Protection and environment | Required IP rating, ambient temperature, dust or moisture exposure, and any corrosion-protection requirements | Protection needs depend on the installation. IP55 is a common industrial motor option, but the required rating should be selected for the actual environment and verified for the complete assembly. |
| Duty and thermal limits | Duty cycle, daily operating time, ambient temperature, and any ventilation or cooling constraints | Continuous operation, frequent starts, high ambient temperature, and low output speed can affect permissible motor and gearbox loading. |
| Compliance and documentation | Applicable destination-market requirements, nameplate details, wiring diagram, outline drawing, and test documents | Requirements vary by destination and application. Confirm the applicable regulations and requested documentation before placing an order. |