| LDPE film tape | Carrier: about 50–100 μm Total tape: commonly about 80–150 μm | Soft, flexible film with high stretch and good conformability. Typical LDPE film elongation is often in the hundreds of percent, depending on grade and test method. | Rubber-based for quick tack; acrylic for better aging and UV resistance. | Bundling, bag closure, temporary packaging, and applications on curved or uneven surfaces. | Conforms well and is easy to handle around irregular shapes. | Check holding power under sustained load; a highly stretchable backing does not by itself guarantee strong adhesion. |
| LLDPE film tape | Carrier: about 25–75 μm Total tape: commonly about 55–125 μm | Flexible polyethylene film with good puncture and tear resistance for its thickness. Properties vary with resin grade, film orientation, and formulation. | Rubber-based or acrylic, selected for the required tack, aging, and surface compatibility. | Securing poly mailers, lightweight bundles, and flexible packaging components. | Can provide a useful balance of flexibility, strength, and material efficiency. | Confirm tear resistance and unwind behavior on the intended dispenser and at the planned application temperature. |
| HDPE film tape | Carrier: about 20–50 μm Total tape: commonly about 45–100 μm | Generally stiffer than LDPE film and can offer good tensile strength at relatively low gauge. Stretch and flexibility depend on film grade and orientation. | Usually acrylic or rubber-based, depending on the required tack and service conditions. | Light-duty bundling, flat-surface packaging, and applications where a thinner, firmer film is useful. | Can be thin and relatively firm while retaining polyethylene’s moisture resistance. | Check conformability on corners and rough surfaces; a stiffer film may lift more readily on demanding shapes. |
| Co-extruded PE film tape | Carrier: commonly about 40–100 μm Total tape: commonly about 70–150 μm | Two or more PE layers can be designed to combine properties such as a tough outer layer and a softer, more conformable layer. Performance depends on the layer structure. | Acrylic or rubber-based; adhesive is selected separately from the film construction. | General-purpose packaging where a balance of handling, flexibility, and durability is needed. | Layer design allows the carrier to be tailored to the application without relying on a single film grade. | Ask for carrier thickness, total thickness, and test data for the finished tape; “co-extruded” alone does not specify performance. |
| Cross-laminated PE tape | Carrier: commonly about 70–150 μm Total tape: commonly about 100–200 μm | PE film layers oriented in different directions can provide more balanced tear resistance than a single-orientation film. Exact strength depends on construction. | Often rubber-based for high initial tack or acrylic where aging resistance is important. | Heavy-duty bundling, reinforcement, and packaging that may face pulling or tearing forces. | Can resist tear propagation and provide robust handling in demanding applications. | Compare tensile and tear test results in both directions, plus adhesive holding power on the actual package surface. |