10 Best Belt Cleaners for Global Buyers?

Rank	Belt Cleaner Type	Cleaning Position	Typical Cleaning Element	Typical Belt Speed	Suitable Belt Width	Moisture Handling	Typical Service Interval	Best-Fit Applications
1	Tungsten-Carbide Primary Cleaner	Head pulley, primary scraping zone	Tungsten-carbide tipped blades	Up to about 5 m/s	500–2,400 mm	Wet and sticky material	1–6 months, duty dependent	Hard, abrasive bulk materials such as crushed stone, ore, coal, and minerals
2	Polyurethane Primary Cleaner	Head pulley, primary scraping zone	Polyurethane blades	Up to about 4 m/s	400–2,000 mm	Wet, fine, and moderately sticky material	2–6 months, duty dependent	Sand, gravel, fertilizer, food-grade materials, and applications where belt protection is important
3	Tungsten-Carbide Secondary Cleaner	Immediately after the head pulley	Multiple narrow carbide blades	Up to about 6 m/s	500–2,400 mm	Dry or wet carryback	1–4 months, duty dependent	High-cleanliness conveyor systems handling abrasive fines and residual carryback
4	Polyurethane Secondary Cleaner	Return side near the head pulley	Flexible polyurethane fingers or blades	Up to about 5 m/s	400–2,000 mm	Moist and moderately sticky material	2–6 months, duty dependent	General-purpose conveyors where low belt wear and simple maintenance are priorities
5	V-Plow Belt Cleaner	Return belt, before the tail pulley	Angled polyurethane or rubber plow blades	Up to about 4 m/s	400–1,800 mm	Dry and damp material	3–12 months, duty dependent	Protecting tail pulleys and preventing trapped rocks or lumps from damaging the belt
6	Diagonal Armored Plow	Return belt, upstream of a pulley	Angled wear-resistant polyurethane blade	Up to about 3.5 m/s	500–1,800 mm	Dry, wet, and coarse material	3–12 months, duty dependent	Tail-pulley protection on conveyors carrying large lumps or material with occasional tramp objects
7	Rotary Brush Cleaner	Return side after the discharge pulley	Rotating nylon or polypropylene brush	Usually 0.5–3 m/s	300–1,500 mm	Dry, fine, and lightly damp material	1–3 months, duty dependent	Food, packaging, agricultural, and light-duty conveying where gentle cleaning is required
8	Air-Knife Belt Cleaner	Return belt or product transfer area	High-velocity filtered air stream	Up to about 5 m/s	300–1,500 mm	Dry dust and light particles	Weekly filter checks; low blade wear	Dry-process lines where contact wear, water, or chemical residue must be minimized
9	Water-Spray or Wash-Box Cleaner	Return belt inside a controlled cleaning enclosure	Spray bars, scrapers, and drainage system	Usually 0.5–3 m/s	500–2,000 mm	Very wet or strongly adhering material	Daily inspection; nozzle cleaning as needed	Slurry, clay, sticky food residue, and processes with available water treatment and drainage
10	Segmented Ceramic-Composite Cleaner	Primary or secondary position at the head pulley	Ceramic-faced or ceramic-reinforced segments	Up to about 6 m/s	600–2,400 mm	Dry and abrasive material	2–9 months, duty dependent	High-abrasion mining and aggregate systems requiring long wear life and segmented replacement